Ganter - Angle joints, stainless steel
Available in 24 variations
DIN 71802
Available in 24 variations
- Bohrung d1: 8 mm - 19 mm
- :
- :
Variant table
available in 24 variations
Stainless steel angle joints DIN 71802 consist of ball cups DIN 71805 and ball studs DIN 71803. The swivel angle is 15° for the version with retaining clip (form CSN), 18° without retaining clip (form CN). During assembly, the ball stud is pressed through the snap ring and held by it. If the holding force (see also minimum pull-off forces in the table) is not sufficient, the connection between the ball cup and the ball stud can be secured by the retaining clip. This is easy to mount or dismount. By using sealing caps, the angle joints are protected against contamination. The hexagon nut is included in the scope of delivery. Sealing caps must be ordered separately.
Specifications
- Pull-off force min. (N): 30
- : 7
- : 8
- : M 5
- : M 5
- : 8
- : 12,8
- : 22
- l1 (mm): 10
- l3 (mm): 8,5
- : 10,5
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.