Halder - Centering clamping elements, with clamping balls
Available in 11 variations
Available in 11 variations
- Durchmesser d1 max.: 14 mm - 103 mm
- Durchmesser d1 min.: 11 mm - 87 mm
For spot centering and clamping of components with location hole when slight ball marks can be accepted. Precise self-centering with an accuracy of ±0.025mm. Due to the clamping balls, components with raw or pre-machined surfaces can be centred and pulled down onto the support points with a force fit. The centering clamping element is characterized by large adjustment ranges and a low overall height.
Screw-on option from above and below.
Material
Base body
- Tool steel, hardened, burnished
Spring
- Stainless steel
Clamping balls
- Stainless steel 1.4112, hardened and ground
Assembly
Installation instructions for assembly from above: Remove clamping plate and screw. Screw in grub screw from below and tighten over inner SW2 from above.
Without SW2, with clamping plate and grub screw can be screwed from above
Specifications
- : 5
- : 10
- : 1,5
- : M4
- : M4
- : 2
- : 3,5
- : 2,5
- : 3,5
- Number of balls n: 3
- : 3
- : 0,5
- : 14,2
- : 11,7
- : 10
- : 1,5
- : 8,6
- : 3,9
- : 3,2
- : 3,5
- : 14,7
- l1 (mm): 3,5
- : 1,3
- : 4