Halder - Floating clamp, combined tensioning and locking M 12
Item-No.: 17000199001
The floating clamp is used for clamping and supporting of over-determined clamping points on components.
The advantages of the floating clamp are:
- Vibration inhibition during machining.
- Clamping of ribs, beads and lugs for stiffening with clamped components.
- Deformation-free clamping of raw parts.
Material
Adjusting sleeve
- Aluminium, red anodized
Base body
- Carburized steel, nitrided, manganese-phosphated and ground
Clamping jaws
- Carburized steel, nitrided, manganese-phosphated
Assembly
- Fix floating clamp (connection thread M 12) with wrench (SW 46) on fixture.
- Adjust height stop and swivel range with red adjusting sleeve and clamp with grub screw (3 x SW 2.5). When adjusting the height limit upwards, allow generous play (workpiece tolerance).
Operation
- Press the floating clamp down.
- Swivel the clamping jaws in as far as they will go. Floating clamp is applied with slight spring force at the bottom of the workpiece.
- Tighten the floating clamp with hexagon nut (SW 18) (min. torque 15 Nm, max. torque 30 Nm). During the clamping process, the workpiece is clamped and supported at the same time.
- Unclamping takes place in reverse step sequence.
Notes
For a safe function, the threaded hole must always be closed, e.g. set screw M 12 x 10.
For specific clamping situations, the clamping jaws supplied as standard can be modified or replaced (see catalogue drawing). (see catalogue drawing: screw ISO 4762 - M8 - 12.9, M max. = 43 Nm).
References
Additional flexible mounting with holder 23470.0250 or retaining bar 23210.0740 possible.
Accessories
As accessories we offer replacement jaws with enlarged clamping range - see 23320.0050-0058, as well as pendulum jaws - see 23320.0148-0156.
Specifications