Halder - Floating clamp, combined tensioning and locking M 16
Item-No.: 17000206001
There is currently no further information available on this article.
The floating clamp is used for clamping and supporting over-determined clamping points on components.
The advantages of the floating clamp are:
- Particularly suitable for large components with heavy machining.
- Vibration inhibition during machining.
- Clamping of ribs, beads and tabs for stiffening with clamped components.
- Deformation-free clamping of raw parts.
Material
Adjusting sleeve
- Aluminium, red anodized
Base body
- Carburized steel, nitrided, manganese-phosphated and ground
Clamping jaws
- Carburized steel, nitrided, manganese-phosphated
Assembly
- Fix floating clamp (connection thread M 16) with wrench (SW 55) on fixture or machine table.
- Adjust height stop and swivel range with red adjusting sleeve and clamp with grub screw (3 x SW 3). When adjusting the height limit upwards, allow generous play (workpiece tolerance).
Operation
- Press the floating clamp down.
- Swivel the clamping jaws in as far as they will go. Floating clamp is applied with slight spring force at the bottom of the workpiece.
- Tighten the floating clamp with hexagon nut (SW 24) (min. torque 50 Nm, max. torque 115 Nm). During the clamping process, the workpiece is clamped and supported at the same time.
- Unclamping takes place in the reverse sequence of steps.
Accessories
For specific clamping situations, the upper clamping jaw supplied as standard can be exchanged for the interchangeable clamping jaws (23320.0062 / .0064 / .0066).
Specifications
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.