Ganter - Universal joint shafts with needle bearing
Available in 40 variations
Available in 40 variations
- Außendurchmesser d1: 22 mm - 58 mm
- Bohrung d2: 10 mm - 30 mm
- :
Variant table
available in 40 variations
There is currently no further information available on this article.
Cardan shafts with plain bearings not only bridge the misalignment of two shafts, but also allow length compensation, which permits a corresponding extension dimension l2 depending on the total length l1. The power is transmitted via two universal joints DIN 808 (form EW), a splined shaft and a sliding sleeve. In the case of cardan shafts, it is essential to ensure that the splined shaft and sliding sleeve are correctly fitted together: the markings => <= must be opposite each other. Wrongly assembled cardan shafts result in an uneven output and lead to rapid wear.
Specifications
- : K, mit Nabennut
- : 28
- : 14
- : 29
- : 60
- l3 (mm): 40
- : 13
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.