Ganter - Bracket for profile systems 30 / 40 / 45, aluminium
Available in 27 variations
Variant table
available in 27 variations
There is currently no further information available on this article.
To fix the brackets, the mounting sets can be inserted through the openings into the profile groove. When tightening, the nut or screw is positioned transversely and thus anchored in the groove. In the case of crossing profiles or when using the brackets with elements without groove, the then disturbing guide bars can be broken out. The cover caps are snapped in over four lugs after assembly. They give the angles an attractive appearance and protect them from dirt. Even after repeated use, the cover caps remain firmly attached to the bracket thanks to the elastic snap-in lugs. If required, these are also available individually.
Specifications
- : 30
- : 28
- : 10,4
- : 6,8
- : 6,3
- : 9,7
- H (mm): 2,1
- h (mm): 2,1
- l1 (mm): 30
- : 30
- l3 (mm): 3
- n (mm): 8
- : 5,9
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.