Halder - Substructure stop
Item-No.: 17000297001
There is currently no further information available on this article.
With the substructure clamp and the substructure stop, workpieces can be clamped on the front side. This allows the entire machine table size to be used for workpiece clamping.
- Low-clamping effect due to inclined arrangement of the clamping jaw
- Clamping of large workpieces possible on the entire table size
- Large clamping force of up to 20 kN
- Clamping travel 10,6mm by means of clamping screw M 16 (SW 14)
- Massive design made of vibration-damping spheroidal graphite cast iron
- Optimum adaptation to workpiece and material by means of clamping inserts and change jaw
- Form-fit and force-fit assembly in T-slot possible
- Low interference contours, even with large workpieces
- Side mounting holes for optional mounting of longitudinal stops
Material
- Spheroidal cast iron (GGG 60)
Assembly
The workpiece is positioned on the ground precision support and then clamped. For customer-specific clamping, machine and fixture parts from the extensive range can be installed in the mounting thread.
Optional length stops can be attached via the lateral mounting holes.
Notes
The interchangeable jaw (ribbed / flat) included in the scope of delivery can be replaced by an interchangeable jaw (soft).
Specifications
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.