Ganter - Stainless steel indexing plunger with knob, with and without indexing lock
Available in 10 variations
Available in 10 variations
- Bolzendurchmesser d1: 4 mm - 10 mm
- :
Variant table
available in 10 variations
There is currently no further information available on this article.
Indexing plungers with flange are fastened parallel to the indexing pin and are thus characterised by a particularly low overall height. The mounting hole pattern with slotted holes offers generous adjustment options, e.g. when used on aluminium profiles. The use of washers favours fastening via the slotted holes.
Indexing plungers with indexing lock (form C) are used when the indexing pin is temporarily not to protrude. For this purpose, the knob is turned 90° after being pulled out and held in position by a detent notch.
The stainless steel versions allow the use of the indexing plungers in more aggressive environments.
Indexing plungers with indexing lock (form C) are used when the indexing pin is temporarily not to protrude. For this purpose, the knob is turned 90° after being pulled out and held in position by a detent notch.
The stainless steel versions allow the use of the indexing plungers in more aggressive environments.
Specifications
- : 3
- : 12
- : 22
- : 6
- : 4
- : 12
- : 7
- : 4
- : 10
- : 14
- : 8
- : 4,5, 7
- : 19
- : 3,3
- : 4
- l1 (mm): 4
- : 10,5
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.