Phone: +49 7443 96729 0

Monday to Friday
08:00 to 12:00am and 02:00 to 05:00pm

Halder - ride-on clamp, pushable, size 40, with eccentric clamping lever

Available in 2 variations

Available in 2 variations

  • Durchmesser d1: 40 mm - 40 mm
  • Hub: 20 mm - 30 mm

You are currently in the B2B area. If you switch to B2C, you will be automatically unsubscribed.
Do you really want to switch to B2C?

Selection filter
Preis
271 €
281 €
Durchmesser d1
40 mm
40 mm
Hub
20 mm
30 mm
Variant table
available in 2 variations
There is currently no further information available on this article.

The ride-on clamp pushable is used, among other things, when swivel movements are not possible due to the workpiece.

The clamps have the following advantages:

  • Easy and quick workpiece change by moving the clamping claw forward or backward.
  • The clamping range in horizontal direction is between l1 min. and l1 max.
  • For workpiece change, the clamping claw can be pushed backwards from l1 max. by the dimension l2.
  • Quick clamping by hand via the clamping screw, the adjustable clamping lever or the eccentric clamping lever on both sides.
  • The use of a positioning ring allows the clamping position to be fixed. Here h1 min. increases by 7mm (stroke minus 7mm).
  • Compact design, therefore low space requirement when clamping.
  • Easy adaptation even to large clamping heights with the height cylinders.

Material

  • Case-hardened case-hardened steel, burnished and ground

Assembly

The ride-on clamps can be attached in two ways:

  • with a nut for T-slots DIN 508 in a T-slot
  • with the grub screw directly into the plate, e. g. e.g. of a fixture

The cylinder must rest fully.

Operation

  • Push the clamping claw backwards.
  • Insert the workpiece.
  • Push the clamping claw forwards.
  • Adjust the clamping position of the clamping claw via the knurled screw.
  • Secure / counter the clamping position with the knurled nut.

References

The clamping height can be increased with height cylinders as well as with washers and reduced by clamping inserts.

Specifications

  • : 20
  • : 30
  • : 40
  • : M12
  • : 90
  • : 70
  • : 95
  • : 15
  • : 28
  • : 38
  • : 107
  • : 90
  • : 13
  • : 115
  • : 55
  • : 100
  • : 30
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar

Please enter a valid email address.
Please enter a valid question.
Fields marked with * are mandatory.

There aren't any asked questions yet.