Ganter - Stainless steel sensor holder
Available in 7 variations
Available in 7 variations
- Bohrung d: 8 mm - 30 mm
- Länge k: 16 mm - 30 mm
Variant table
available in 7 variations
There is currently no further information available on this article.
The stainless steel sensor holders are used to hold sensors that are fastened with two lock nuts. The mounting hole is matched to the central thread of surface-mounting clamp holders. With k=30, the cross-shaped slotted holes allow additional adjustability and the use of two fastening screws. Mounting screws are not included in the scope of delivery.
Specifications
- D (mm): B 8
- d (mm): B 8
- k (mm): 16
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.