Halder - Pull-down clamp, without lever, with flat clamping jaw
Available in 3 variations
Variant table
available in 3 variations
There is currently no further information available on this article.
By tightening the ball pressure screw, the workpiece is simultaneously pulled down against fixed stops and onto supports. The favourable lever ratio allows high horizontal clamping forces. Can also be used with nuts for T-slots in other nominal slot dimensions.
Material
- Steel, case-hardened, burnished, ground
Specifications
- : 3
- : 10
- : 7
- : M8
- : 8,4
- : 24
- : 20
- : 8
- B (mm): 32
- b (mm): 32
- l1 (mm): 52
- : 28
- : 3
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.