Ganter - Stainless steel sensor holder, for adjusting rings GN 7062.1 / GN 7072.1
Available in 13 variations
Available in 13 variations
- d1: 8 mm - 30 mm
- k: 14 mm - 30 mm
Variant table
available in 13 variations
There is currently no further information available on this article.
The stainless steel sensor holders are used to hold sensors which are mounted with two lock nuts. The d2 holes are dimensionally matched to the mounting threaded holes of the set collars and allow axial or radial positioning of the sensors.
Specifications
- : B 8
- : 3,5
- : 8
- k (mm): 14
- l1 (mm): 13
- : 9,5
- l3 (mm): 15
- m (mm): 8
- : 2
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.